Home > News > Content

Hot Pressing Grouting Mold Does Not Appear Rubber And Shot Does Not Move The Fault

Aug 02, 2017

Hot Pressing Grouting Mold does not appear rubber and shot does not move the fault
For Hot Pressing Grouting Mold, if it is not the phenomenon of non-gel, we have to know to see it's shot coil electromagnetic coil is not the phenomenon of burning, or there are foreign objects into our direction of the valve, Moreover, the card is moving with the spool, or will be for the plastic injection valve to be replaced; or, for hot pressing grouting mold pressure is too low, but also to increase the pressure of injection can be.
For the Hot Pressing Grouting Mold does not appear to the case of plastic injection molding into the temperature is relatively low, this time is to adjust the thermometer for our temperature directly to the requirements of the point can be raised. But adjust the thermometer or can not increase its temperature, it is necessary to check the electric heater and the fuse to see if it is not burned or loose phenomenon, if it has been broken, but also to be replaced in a timely manner of
For the hot press grouting mold, its sol screw rotates, and in terms of its compound, it can not enter the barrel. In general, the back pressure of the sol after its sol is relatively high, it is necessary to adjust or replace the sol backpressure valve when it is damaged or improperly adjusted.
Hot Pressing Grouting Mold of the shooting station does not move the phenomenon, then, for its shooting table limit limit stroke switch is concerned, it will be adjusted to hit the block pressure, then the direct adjustment can be; for the shooting table The solenoid valve coil is also possible to have burned out or there is a foreign object into the direction of the valve to carry the card to move the spool, then we need to clean its solenoid valve or replace.
When the shot of the Hot Pressing Grouting Mold can not move, the speed of the advancement of the shooting table is checked to see if the pressure is not suitable for the adjustment. In addition, the I / O board of the hot- , The direction of its valve output voltage is to be checked to see if it is not normal, if it is not normal, it should be the output of the transistor or relay, etc. to see if it is not already damaged.
 In view of the current development trend of Hot Pressing Grouting Mold, we should pay attention to the fact that, in recent years, it has been a rapid development of digital technology which has been developed directly in recent years to solve the hot- Development is directly facing the many problems of an effective way, it is precisely because of this, we are concerned with the development of the words, in fact, is to pay special attention.
     In addition, we actually have to pay attention to, we talk about the Hot Pressing Grouting Mold digital technology, in fact, that is, computer technology or computer-aided technology CAX in our mold design and manufacturing process directly on the application. It is also because of this, when we directly summed up the domestic and foreign automotive mold enterprises where the application of computer-aided technology to a successful experience.
     In addition, we actually have to pay attention to the Hot Pressing Grouting Mold for the development of digital technology, which is the main fact that it will directly include the design of the design (DFM), in fact, that is, when the design, a certain To consider and analyze its manufacturability to ensure the success of our craftsmanship.
     Hot Pressing Grouting Mold digital technology development also includes a mold surface design of a supporting technology, in terms of this aspect, we actually have to pay attention to the direct development of an intelligent surface design technology; Moreover, In fact, it is necessary to pay attention to CAE auxiliary analysis and simulation of a process of forming, so that we can actually directly predict and solve it may be a defect and forming problems.