Home > News > Content

Mold Production Of Ceramic Products Production In The Process Of Forging Which Will Change

Jun 23, 2017

Mold Production Of Ceramic Products production in the process of forging which will change
Under normal circumstances, ceramic products in the production of brittle cutting effect, in fact, much better than plastic, and can more easily meet the relevant processing requirements, but for the same material, in the metallographic structure, if it is more Small words, then the better, this point in the industry are more recognized.
       First, the Mold Production Of Ceramic Products production In forging equipment, if it is based on the weight of the forging classification, then it is best to use tonnage larger mold or equipment, and in forging should be used before the hammer or hammer drill Mold preheating in advance to ensure the good operation of the production process.
       Second, the preparation of ceramic products in the blank powder preparation, blank material in the cutting time, it is best to be cold saw, and ceramic products according to the different requirements of the mold, in the choice of raw materials, should be selected in accordance with the level , Different materials using different molds, so that the processing will be more accurate.
       Third, the Mold Production Of Ceramic Products production billet heating, the blank for heating, it is best to slow to prevent the rapid heating of the way to avoid the phenomenon of burning, and in the heating process, the temperature should not limit the lower limit , If the case of burning, it should first be its temperature and then in the forging.
       If it is more than the production of ceramic products for the production of heating, each piece and between each piece, in the heating must ensure that there is a certain gap, and throughout the heating process, we must always flip the parts to ensure that There will be no bonding between each other to ensure that the product processing and use of normal.
       After the cutting of ceramic products die production in the contours and shape is still relatively poor degree of roughness, and pure structure and made from the contours of a large difference, mainly because of the cutting process, the plastic appeared serious Of the deformation, and we in the cutting time, the choice of the tool is also more important.
       Because the different tools in the precision, as well as fine cutting high and low speed will have an impact, serious will affect the entire ceramic products, the normal use of mold production. If the brittle ceramic products for the production of mold material processing, then the rate of cutting for the roughness of the impact is not large.