Home > News > Content

Mold Production Of Ceramic Products Should Pay Attention To Its Toughness And Corrosion Resistance

Oct 13, 2017


When it comes to Mold Production Of Ceramic Products, it is important to pay attention to the toughness of the mold itself. Relatively large impact load, in this way, that is, to a large extent, in fact, it will be more likely to lead to Mold Production Of Ceramic Products fracture phenomenon.
In addition, in order to prevent Mold Production Of Ceramic Products parts in the work of the time when the sudden fracture of the phenomenon itself, in terms of the mold itself, in fact, it will have a relatively high strength and toughness. And the toughness of the machine mold in terms of its very large extent, it is mainly depends on the carbon content of the material itself and its grain size and organization and inclusions in the content and its strength.
Then, on the selection of Mold Production Of Ceramic Products, we actually have to pay attention to its own corrosion resistance, some mold on the mold when the work, because there is a plastic chloride, fluorine And so on, on this point, we actually have to pay attention to it in the heat after the fact that it will be directly on the decomposition of the HCI, HF and other strong corrosive gases.
There is also for the Mold Production Of Ceramic Products on the aggressive gas in terms of, to a large extent, in fact, it will directly attack the mold cavity surface, so that its surface roughness is actually will be Increase, in order to, in its great extent, in fact, it will directly increase the wear on the failure of the phenomenon.
Finally, the choice of Mold Production Of Ceramic Products is actually a relatively high temperature performance, the Mold Production Of Ceramic Products on the work of the temperature has increased, to its extent, in fact, that is It will make its hardness and strength in fact it will be down, in terms of this aspect, to a large extent, in fact, it will lead to the Mold Production Of Ceramic Products early wear or plastic deformation occurred failure The
On the current Mold Production Of Ceramic Products in terms of casting, we first have to pay attention to the fact that is included in the equipment forging. In terms of this point, if it is in terms of the weight of the forgings in terms of its weight, it is on the Mold Production Of Ceramic Products short hammer, in fact, we should pay attention to the tonnage should be above the choice.
It is precisely because of this, before it is forging, we actually have to pay attention to it should be directly on the Mold Production Of Ceramic Products directly on the hammer drill and hammer side of the preheating treatment, on this point In fact, it is very important, in terms of this point, we are in the processing time, must not be ignored.
In addition, we actually need to pay attention to the Mold Production Of Ceramic Products on the preparation of the blank, the blank itself, in terms of its cutting time, we have to do is to pay attention to it should be To be directly on the cold, but on this point, we actually have to pay attention should be based on different types of Mold Production Of Ceramic Products in the different aspects of the relevant requirements.
In the choice of Mold Production Of Ceramic Products on the raw materials, we actually have to pay attention to it should be in advance to the carbide grade in the above classification, followed by, in fact, we should pay attention to should be directly on the selection of suitable Forging a series of carbide products, under normal circumstances, the three times per ton in the pull, we actually have to pay attention should be able to progress 1-1.5 or so.
Finally, we actually have to pay attention to should be directly on the blank related to the heating behavior. The whole process of heating in terms of, to a large extent, it is necessary to pay attention to should be carried out slowly, on this point, in a very large extent, in fact, is to prevent the rapid heating of the situation, In this way, when Mold Production Of Ceramic Products is cast, it will be able to avoid the situation of burning.